Ford Racing 2005-2010 Mustang GT Billet Throttle Body

Product Description

Ford Racing 2005-2010 Mustang GT Billet Throttle Body

From Ford Performance:

• Fits in factory location on 2005-2010 Mustang GT
• Does not include calibration, CALIBRATION REQUIRED, sold for tuner use
• Twin 62mm bore (stock Mustang GT is twin 55mm)
• CFM Rating: 1306cfm (stock dual 55mm throttle body: 953cfm)*
• Precision machined from billet aluminum to ensure consistency
• Polished finish with CNC'd Ford Racing logo
• Fully assembled complete with throttle position sensor and actuator motor, ready to bolt on!
• Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies
• Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past.  
• Works well with Ford Performance M-6550-3V hot rod camshafts, M-6049-N3VPA high performance CNC ported 3V Cylinder Heads and Ford Perforamance M-9424-463V performance intake manifold. Calibration Required.

All Ford Performance ETC throttle bodies feature:

• All factory sensors installed - no need to tear apart your original throttle body
• Calibrated for idle air flow using the same procedure as production throttle bodies
• Precision billet construction with tapered inlet for consistent high flow
• Polished aluminum for great looks and underhood "bling"
• Throttle body features CNC'd Ford Racing logo
• Validation through hundreds of hours of dyno, racing, and street performance driving

*All cfm ratings are calibrated at 28-inches of water, measured on SuperFlow SF-1020 Flow Bench.